How to ... Hot tub

prepare and use the Hot tub in a few easy steps ! 

First of all ... don't panic, it is easy ! We are just charing this for you, to help you figure it out quickly. 

Step 1 : Open protective lid and check if it is full of water. If it is... check it is filled at least 15cm above the highest 'hole' you can see in the middle console. 

Step 2 : Fill with water, just by attaching the water-hose and turning on the tap. If completely empty, filling takes about 30min. 

Step 3 : Fill the chlorine capsule with one pellet and drop into water. (looks like a plastic mushroom and can be found on the cupboard next to the washing machine) 

Step 4 : Close protective lid to keep the heat in which heating.

Step 5 : Once full of water you can start heating. Use the short cut wood provided in the cellar and start with a gentle fire to gradually go hotter in fire-heat. 

Warning : NEVER PUT THE FIRE ON BEFORE IT IS FULL OF WATER. 

Step 6 : Put the yellow fishy thermostat in the water to check temperature. 

Step 7 : Use the paddle to mix the water and help spread the hot water. Heating for the first time takes about 2 hours. Reheating takes about 30min.

Step 8 : Once the temperature is right. Put one or 2 more blocks in the heater and close the airslots... then rinse yourself down. 

Step 9 : Remove the lid completely it's time to get in ! 

Step 10 : RELAX & ENJOY :)

Step 11 : When you leave the Hot tub, put the protective lid back on ! It wil keep the Hot tub very warm and the next day you will hardly need to heat it again. 

Step 12 : Once you decide not to go back in. Please empty the Hot tub :) Don't forget to remove the Chlorine casing. There is a hose to attach so the water runs down the garden into the treeline.

Step 13 : There is no 13 :) That was it ! Easy-peasy !